You can manually add the coordinate of any node to be added from here.

To access the STAAD editor, go to the Edit tab > Edit Input Command File, then the editor will pop-up.Īfter joint coordinates, you see four set of number separated by comma (,), the first number in each number set is the node number, the remaining 3 are the node coordinate. Node can also be added from the STAAD editor. To add node using this method, go to the Geometry tab > Snap/Grid Node > Beam and then click anywhere on the graph like structure that appears on the interface and a node will be added. Nodes can be added by defining the X, Y and Z positions of the points on the node table in the model view. A node can be added on STAAD.Pro using any of the three (3) methods below. It’s a point where boundary condition applies, stiffness condition are changed, structural supports are added etc. Node is the smallest unit on which other modeling entities are built. Modeling on STAAD.Pro can be achieved using five (5) basic modeling entities which are Modeling is a physical representation of a structure, which is the first step to take to design any structure on any software. On STAAD.Pro, the construction materials that can be analyzed and designed are Ĭomposite materials i.e combination of two or more construction materials in a single model can also be modeled, analyzed and designed on STAAD.Pro Creating Models

It is a structural engineering software majorly used to design structures such as buildings, bridges, industrial structures, retaining walls, dams, culverts, plant structures etc. STAAD.Pro is a 3D modeling software developed by Research Institute Engineers International in 1997, later bought by Bentley.

Staad pro introduction pdf